sensor machine

Home > sensor > sensor machine

May 16th, 2008 admin Leave a comment Go to comments

One of the best things to Powis Parker Fastback binding machine 9 is that if there is a problem, it provides you with an error message that helps you figure out what is wrong. This article is designed to list the most common error messages, possible causes and possible solutions. By using this article you should be able to do some basic troubleshooting of your machine and hopefully will find a simple solution to your problem. Here are some of the errors you may encounter:

Error message: "INSERT BOOK"

This message can occur if you press the bind button on the machine without putting a book in the binding depth of Fastback 9th Put a book in the machine and try to press connect again.
This message can also occur if the sheets in the document are not fully justified in the right side of the mandatory break. To address this problem, pointing to the edges on your sheets until the book is close to the right side of the mandatory break.
This message may also appear on the paper sensor is damaged or not working correct. If so, you must contact your dealer Powis and arrange a service call to replace the sensor.

Error message: "Use smaller size "

This error message usually appears if your band is too large for the number of sheets are placed in the binding depth of Fastback 9th You can either add more leaves or use a narrower strip.
This message can also occur if you forget your flip LX binding ties in 90-degree angle before it is inserted into the machine. If so, simply add your band and try to bound the cycle again.
This message will also appear on the strip and the contents of your book is not properly lined up on the back of the mandatory break. Verify that the contents of your book and tape are completely pushed back into the machine.

Error message: "BEECH too fat"

This error if you try to tie too many sheets of paper with the medium strip. You will need to reduce the thickness of the book by removing any sheets. The Fastback 9 is limited to approximately 1 inch capacity by using a medium LX strip.

Error Message: "USE MEDIUM SIZE"

This error message can occur if you try to tie too many leaves with a narrow strip. You can either remove any sheets or use a narrow strip LX instead.
You can also get this error message if there is no tape in the recessed binding and you press the bind button. The machine will measure your documents and tell us what type of tape you need to use.

Error Message: "use the long narrow format"

This error can occur if you try to tie too few sheets with a medium band. You can either add a few leaves or using a narrow strip.
You can also see this message if you insert a document into the mandatory recess and then bind the button without inserting a tape. The machine will measure and document tell me what size of band you have to use.

Error message: "reverse Strip

This appears if you try to bind a document with a strip in the rear. You must ensure that the short end of the strip is vertical and the long end is flat.

Error message: "Engine ERROR XX"

This series of errors is to say that your machine needs technical attention. Try your machine off and then back. If the error persists, contact your Powis Parker dealers and establish a service calls.

If you are interested in more information about the Powis Parker Fastback 9 or are looking for Fastback Binding Machines or Fastback Binding Strips you should visit MyBinding.com. They are the largest online dealer for Powis Parker Fastback products in the United States. In fact, they carry the entire line of Powis Parker Fastback binding products.