sensor circuit schematic
Trying to get American Standard Jacuzzi tub to work. Can not find manual. On / Off Switch broken.?
There is only 1 black wire leading to the transition, which makes no sense to me - should be 2 wires to form circuits. Green wire leads to the sensor water. How can I get a manual or diagram to find out how to wire the new switch. Pump model number is 01-2706 Black Wire (not air tube) ends with a female tab connector that goes to the switch, switch mount in the upper right corner of the tub. Black cable leads to a junction box near the blue pump. About 6 inches before the pump is equipped with a black wire pin female connector that is open. Hence the black wire is a card attached to the top of the blue field. Alongside this is a white wire connected to a blue card box and runs on water level sensor.
This may be wire, but the air tube. Many of these switches are remotely air pressure will not be a bad switch, but the air leak. Now you can have a wired switch, but I'd cut There may be 2 wires on the black sleeve. Checked and it would be provocative air switch leaks so check first!
 |
No items matching your keywords were found.
